Issues in SCM after Live Cache re-initialization

[Former Member]

Dear Experts,

We recently performed an activity of dropping the live cache and re-initializing it for one of our project requirements which is stated below.

Requirement:There was a demerger happening for our client in which few of the asset companies within our Client were separating and forming a new company.

Naming for old company - ABC and new company - XYZ.

XYZ was shifting completely to a new system and they wanted us to clean all the data pertaining to ABC from their system.

We used SLO to perform deletion of data belonging to ABC from the APO data base and to delete the data from live cache ,the live cache was dropped (which deleted ABC & XYZ data from live cache) and then reloaded from data base ( re- initialized the live cache).

The following issues were faced after re-initialization of livecache.

a)All the transactional data even belonging to XYZ was deleted from the system.

b)While trying to load data in DP planning book , received error "key figure does not exist" and planning book could not be processed further.

c)While running the planning area consistency check , received error "storage bucket profile does not exists in the live cache".

Can anyone help on how to correct the issue if you had a similar situations in the past.Any suggestions would be helpful.

Thanks

[former_member229109]

Hello Geethika p,

you already reported the case in SAP message. Correct?

I recommend to close this thread to avoid any misleading information.

a) The transaction data will be lost after you will initialize the liveCache in LC10.

Review the SAP note:

640107

Using program /sapapo/delete_lc_anchors in APO 3.0 or higher

You could bring the transaction data back via initial transfer from R/3 system and TS data need to be loaded from backup infocubes.

b) See a) on TS data.

c) Case was that you initialized the liveCache and selected the option as for migration or upgrade.

    Then used //om17 to correct inconsistencies.

    I was wrong.

    You could not use the option as for migration or upgrade when you run the liveCache initialization in LC10, if you are NOT run the system migration or upgrade.

Best regards, Natalia Khlopina