on 07-16-2015 1:52 PM
Hi Guru's,
I am getting an issue in inspection lot creation w.r.t. PM Order and that is i am getting UOM as PH but i am expecting EA,but i am not getting from where inspection lot is picking this UOM PH.
Kindly let me know how to figure out from where i am getting this UOM.
With Regards
Hello,
Inspection lot 14 is not linked to any material so the unit of measure is set "in hard code" using the unit linked to the ISO unit which can be found in CUNI for the unit of measure.
Natália
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
hi
ref to above send the screenshot.
thanks
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
107 | |
12 | |
11 | |
6 | |
5 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.