cancel
Showing results for 
Search instead for 
Did you mean: 

No entry found for process-oriented storage control for XXXX IB01 0001

Former Member

Hi,

I have assigned delivery and door to TU, when i press the create WTs button the following error is throwing.

"No entry found for process-oriented storage control for XXXX IB01  0001"

in last transactions i have created unload WT in (/SCWM/PRDI)  POSC process successfully i.e IB01, IB02, IB03

there is no log also in SLG1

but now the error showing

So, pls advise me any config. missing.

Thank you

VIJAY

Accepted Solutions (1)

Accepted Solutions (1)

Former Member
0 Kudos

Hi Vijay

when you did last one hope you was not having TU connected to your flow.

solution for this is.

go to posc for your wh and remove above entry

WH NO IB01  0001

hand insert wh no + IB01 and blank HU type. it will accept your flow.

Regards

Suraj

Former Member
0 Kudos

Hi Suraj,

Even i tried to solve the above problem as you suggested but no solution.

the issue is same as

pls find screen shots for your refere.....

FOR POSC SETTINGS

Thanks

VIJAY

Former Member
0 Kudos

Hi Vijay

First remove CENI your combination and insert as below

CENI + IB01 9030 0001 3065 to 9010 0001 Gr- Zone.

and try with new document flow and leave..

And reply what issue your are getting.

Also assign door to TIU and use unload wt for your work. I have received this conflict many time. will assist  for resolve.

Regards

Suraj

Former Member
0 Kudos

Hi Suraj,

You are absolutely right the issue is resolved now

Thanks Suraj

Regards.

VIJAY

0 Kudos

I used TU too, and when I created WT in IBD of hu table, the system give the same message.

I create WT for IBD

posc configuration as below

if i didn't use TU function, i can create HU WT. could you help me to fix it ?

0 Kudos

storage process step

Answers (0)