Issue activating SCM_SNC_GEN2 and update to ECC bill of Lading number

[Former Member]

Hello Expert

this is a question to all who have already active SCM_SNC_GEN2

I was also planning to activate SCM_SNC_GEN2, in my system

I was to use this to update Bill of lading and Carrier name at the time ASN

I don't want to use any other functionality ...I would like to  know following

1. 1. Does this data updated in SNC web UI for ASN on publish updated to ECC
2. 2. We have only implemented PO / SMI / Invoice collaboration (this is self billing); do you this my existing setup would require changes

Regards

Manas Malhotra

[Former Member · Accepted solution]

Hello Folks

Thank you for your reply

the thing is have already conducted the test for BOL and Carrier ID; my issue was related to massupload of ASN using upload and down load centre

where if you have not activated GEN2 ; BOl and Carrier ID as fields are not available in the download file

So wanted to know what are the effect if I activate GEN2

I did try it out , and there are no issue reported as such; there are some new XML that can also be used for PO collaboration etc

But in call I found no issue

Thanks for your help

Regard

Manas Malhotra

[former_member194108]

Hi Manas,

Please find my answers below:

1. BOL & Carrier name will be sent to ECC at the time of ASN. You can find them in Inbound Delivery. You may need to activate Validation checks to make BOl & Carrier Mandatory while publishing ASN.

2. Normally no new setup is required. Please check PI mappings in case you are not getting it in ECC.

Regards,

Rahul Sharma

[Former Member]

Hello,

1. Yes the data on the WEB UI ( i.e Bill of Lading) will be updated on the ECC side on the inbound delivery.

2. Would need to see my details, but I don't believe so.