06-30-2015 8:57 AM
Dear all
Related to an older discussion
which didn't provide a concrete answer I'd like to know if it's meanwhile possible to make the code inspector block the release of the transport in case errors are detected during the code inspector check.
The current behavior is that a pop-up appears during the release of a transport indicating that there are errors, but you can still continue the release by clicking the button 'Continue'. I'd like to get rid of that 'Continue'-button.
Thanks for your input and best regards
Dimitri
06-30-2015 2:46 PM
Hi Dimitri,
For this kind of block, I think you need to look at the ABAP Test Cockpit (ATC). But there is some setup to do.
Here is a good introduction.