Scip holiday in IP10

[Former Member]

Hello, all.

When I creating shedule maintenance plan in t code IP10, the holiday are skipped in WO basic start date. But in another system this behavior does not working. How and where I can see this customizing?

[Former Member · Accepted solution]

I'm sorry. Holidays are should not be skipped, but in our system they are skipped

[MTerence · Accepted solution]

Hi Pavel,

Refer below thread for linkages in PM. Kindly check those configs.

Regards

Terence

[Former Member · Accepted solution]

Thank you!

If work centre(D2I04E01) was assigned to Factory Calendar, then holidays are not counted.

[sebastian_lenartowicz]

Greetings Pavel,

Can you provide the following information:

1) What Factory Calendar is maintained on the "Maintenance Plan Scheduling Parameters" tab and is the Scheduling Indicator set to "Time - Factory Calendar"?

2) What Factory Calendar is maintained in the Capacity for the D2I04E01 Work Centre (tab Capacity > Capacity Category > Available Capacity)?

The former will drive the IP10 schedule, the latter is by standard used for Order scheduling, depending on the Order parameters.

[MTerence]

Hi Pavel,

What are the maintenance scheduling parameters you are using ?

Check the Factory Calendar in the scheduling parameter

Regards

Terence

[Former Member]

This parameter is empty, and our Customer say, that it should be assigned by default using werks. But i don't find this customizing or exit