on 05-29-2015 12:31 PM
Hi everyone,
I did the reverse engineering of a schema from an Oracle DBMS and then I put in the repository. I could make changes to the model and save them in the repository, but, at one point, I had to do the reverse engineering of the model again and, after that, the model missed the references to the repository not allowing comparison between models and I couldn't do more any check in the repository.
I would like to know if I am doing something wrong or if this is a PowerDesigner normal behaviour. I am using PD 16.5.
Thanks in advance.
If you check out the model and compare with the local one, can you get right result?
Are you on 16.5 base release?
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
87 | |
10 | |
10 | |
10 | |
7 | |
6 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.