cancel
Showing results for 
Search instead for 
Did you mean: 

GRC AC 10.1 - Access Request Error "Parameter...is not valid for system..."

Former Member
0 Kudos

Hello

We are experiencing an error in our access requests for FF IDs that says "Paramater xxx is not valid for system x" (See below). The request can be completed when the parameter is removed from the SU01 record. Is this possibly related to the parameters in the set user defaults area of SPRO? Does anyone know how to resolve this without removing the parameter settings in SU01? I've tried searching other SCN posts and SAP service marketplace but didn't have any luck except for one note but it was related to CUA and we are not using CUA.

Thank you in advance.

Accepted Solutions (0)

Answers (1)

Answers (1)

former_member197694
Active Contributor
0 Kudos

Hello,

Please check the below parameters and try

maintain 2051 to YES

maintain 5024 to YES

hope this should resolve

Regards

Baithi

former_member185447
Active Contributor
0 Kudos

Hello SCHWARZ,

Check Whether the parameter exists in the table TPARA in the backend.

Also, Check If the value is accepted or valid value for the parameter.

Check if you maintained the correct parameter and value in SPRO -> IMG -> User Provisioning -> Default Values.

Regards,

Deepak M