PPM 6.1 Installation - Table "/BOFU/D_BFI_ROOT" could not be activated

[Former Member]

Hi,

I try to install PPM 6.1 on NW 7.4

I use SAINT to install WEBCUIF / SAP_BS_FND / MDG FND and i have this error :

If i go on log interface i have this error :

and more precisely :

I have this errors :

1 EDO578XThe following errors or warnings have occurred:

1EEDO519X"Table" "/BOFU/D_BFI_ROOT" could not be activated

1EEDO519 "Table" "/BOFU/S_BFI_ROOT" could not be activated

1EEDO519 "Table" "/BOFU/S_TEST_ROOT_BFI" could not be activated

1EEDO519 "Table Type" "/BOFU/T_BFI_ROOT" could not be activated

I try to activate manually "/BOFU/D_BFI_ROOT" using SE14. It's doesn't works

The table doesn't exist

How i can resolve my issue ?

Thanks in advance for your replies

[Brendan_Ward · Accepted solution]

Hi Michael,

SAP Note 1998615 describes the root cause of this issue and the solution. You will need to carry out the manual steps of the note.

During your manual operation, if alert pops up indicating that the namespace /BOFU/ does not exist, please do the following steps:

1, Create the namespace /BOFU/ in transaction SE03 (Display / Change Namespaces) with the namespace role "C" and the repair license "09203831381640008162"

2, Set the namespace to "modifiable" in transaction SE06

3, Go ahead with the manual steps described in SAP Note 1998615

(Make sure that you release your repair request before you continue with the installation)

Best Regards,

Brendan

[Former Member · Accepted solution]

Oh thanks a lot. It works particularly well.

[Former Member]

.

I have  faced same issues and referred your Answer   . Its working Fine  .

Thank you  Brendan Ward