Error in warehouse task creation for simple putaway process.

[Former Member]

Hi Dears,

i am going to create warehouse task the following error is throwing

Maintain the number range interval /SCWM/TO for warehouse tasks

Message no. /SCWM/L3040

But i have maintained number ranges for the same

pls find the below number range

I have check log in SLG1 the error is as follows.

Please tell me how to solve the issues.

Thanks

VIJAY

[Former Member]

Hi Vijay

check same no is assigned to wh in same config.

also create no range for WO also.

check have you created GR zone bin and final bins.

activate log for WT in /SCWM/ACTLOG and post log here.

regards

Suraj

[Former Member]

Hi Vijay,

you should create number ranges and then check if same is assigned to your Warehouse i.e. 01 or 02 and you should create number ranges for Warehouse warehouse task and warehouse orders as well.

The screens which you have attached, does not give a enough details about the issue, please activate the log for warehouse task as advised by Suraj in previous reply, and then try again and post the log details.

Regards
Anoop

[Former Member]

Hi Suraj and Anoop,

Thanks for your Reply

I think application log activation is not required

every setup has done by me on before only.

but one small sequence has missed out.

now the issue was resolved by me.

Thank you for your support

Thanks a lot

Regards.

VIJAY