on 05-07-2015 6:43 PM
Hi,
I am trying to create an inspection plan and attach inspection characteristic to it.
- Every time I am trying to assign an inspection characteristic, I am facing this warning message:
Sometimes I also get an error for the same inspection plan and MIC (this is erratic behavior by the system that it is sometimes error and sometimes warning) :
However in the QM settings for the plant - I have maintained that no version management is required for MICs:
And the MIC is released :
I am not sure why system is giving me these messages..
- While checking the consistency I also get warning message that defects are not assigned whereas I have explicitly assigned defect codes to this MIC:
Any help will be highly appreciated.
Regards
Snigdho
Hi,
Check the "Valid from data" of the inspection plan and MIC, the validity of MIC should lie within that of the inspection plan.
Daniel
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.