on 04-23-2015 7:23 PM
Hello Experts,
We have a BAdi on BPC10 SP17 that sends information from BPC to ECC (Retract). We have everything setup, when we run the data Manager it finishes succesfull, but when checking the ECC report it doesn't show any information.
I am suspecting that it is bc the Cost Centers in BPC are made <prefix><ECC cost center ID>.
Would it be correct to do a transforation file to remove the prefix or it must be done in BW?
If it is a BPC tranformation File.
How can i do it?
Thank you in advance.
Best Regards.
Hi Sebastian,
If you are using a BADI to do the retraction then you don't need a transformation file to remove the prefix, you can do that in your BADI.
Ask your abaper to debug.
Andy
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
We do use BAdI for retracting the data back to BW or ECC. Here we cannot use transformation file since end target should be BPC model for transformation file. This is no the case in this scenario. Here you have BW cube or ECC table as the target, so you can change the logic in BAdI to remove the prefixes or to bring the data in desired format. Thanks
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
16 | |
3 | |
2 | |
1 | |
1 | |
1 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.