on 04-07-2015 4:28 AM
Dear All,
i wanna implement CTS+ on PI to transport non-abap objects , so far i completed the following task
1. completed stms configuration
2. completed cts+ configuration
3. complete the transportation from d to q
but when i do the transport from Q to P, no target system in CR 's properties like showed in attached screen shot.
could anybody help me on this issue. your answer and reply would be great appreciated
Thanks a lot
Kevin Gao
>>>but when i do the transport from Q to P, no target system in CR 's properties like showed in attached screen shot.
This is because you have configured CTS+ only from D->Q
However are you sure you really want to export them again from Q -> P
Ideally, in order to maintain consistency(best procedure's) you should transport the same request from
D-> Q -> P
You don't need to export/create the req again in Q to move it to P.
You can go to STMS -> Transport routes(SHIFT+F7) -> Configuration -> Standard Configuration -> Three Systems in Group.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Kevin,
The CTS+ general configuration is required in all SAP boxes. Please refer the point 4 of below doc
regards,
Harish
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Kevin,
Please find the link again (you can also click the word link)
User | Count |
---|---|
87 | |
10 | |
10 | |
10 | |
7 | |
6 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.