cancel
Showing results for 
Search instead for 
Did you mean: 

SAP QM

Former Member
0 Kudos

Hi SAP Techies,

I have some materials having quality activated 01. Last week i have deactivated 01 inspection type from QA08. but now when i have acctivated again 01 inspection type from QA08. now when i release material from MIGO / MB1B system gives me error as

Change the inspection stock of material RKHECB280000005400 in QM only

what should i do?

Accepted Solutions (0)

Answers (2)

Answers (2)

busyaban7
Active Contributor
0 Kudos

Hi Saransh,

Please can you confirm the below points -

a) While you deactivated the inspection type 01, if there were some q-stock available in MMBE. Use QVM2 to clear any open Q-stock.

b) If there were some open inspection lot available in QA32 in SPRQ status. Put UD against these inspection lots.

c) If there any open Purchase orders with Quality active. Please flag these PurOrd as 'Unrestricted Use" in change mode and complete the steps.

Please can you also check the SAP Note - https://websmp230.sap-ag.de/sap/support/notes/212238

Thanks,

Arijit


jude_bradley
Active Contributor
0 Kudos

Hello Saranash,

This is the SAPGUI forum, you will get a better chance of a good answer in the QM space

A few minutes searching first, will give you a better chance later on.

Jude