on 03-30-2015 8:19 AM
Warning - "Role not generated on default connector" when creating a composite role with derived roles:
Hi All,
I get the above error message post addition of roles in the define roles phase of the Role methodology process.
I have referred through the below note which is valid for Business roles and is for GRC 10 SP12 whereas we are on GRC 10 SP16. I couldn't find a similar note for the Composite role.
1794860 - Warning message not correct when generated roles added in BR
Any inputs/notes would be helpful to address this issue to closure.
Regards,
Arun
Dear Arun,
i assume master role of derived roles are exist in GRC BRM,if not kindly check the status of those roles and then try add into them.
Regards
Baithi
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear Arun,
Are you using multiple connectors for backend systems
As per the error message "Role not generated on default connector"
Use the same connector for all types of roles,
Ex:
you can re import the master role and derived roles once using default connector and then try for addition into composite roles
Regards
Baithi
Arun,
did you sync the roles for the default connector? After importation of the roles the flag "Role exists" is set to NO for the imported roles. Hence you need to run the sync job (prefferably full sync mode) once before you can use them in BRM properly.
Let us know if it works.
Regards,
Alessandro
Thanks for your inputs!
@ Srinivas - There are multiple connectors present in the "Maintain mapping for actions and connector groups" maintained in configuration.
However, the ECC Dev system is maintained as default. Also, I have imported both the master and derived role with required role attributes. The roles show the following in the provisioning section,
Role status - Production
Role exists - Yes for ECC Dev
Role provisioning allowed - Yes for ECC Dev
Allow auto provisioning - Yes for ECC Dev
@ Alessandro - Apart from the above I have also re-ran the Rep sync post role import, but still have the same issue/error.
Please update if I am missing anything more or any note needs to be considered.
Regards,
Arun
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.