on 04-10-2007 7:51 PM
Hi
While creating the partner profile (we20), by default the outbound parameters are disabled,
how to enable the outbound parameters to enter the data(message type).
Thanks
ss
Message was edited by:
s s
Hi,
There should be a small "+" green sign below the table control of outbound parameters.
When you click on this, it will take you to the screen to maintain the required paramters.
Hope this helps,
Sumant.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
93 | |
10 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.