Multiple Inspection Results for a Single MIC
We have a scenario where we need to enter the results 5 times for a single characteristics. And need the average value.
However other MIC in the same operation will have One Result for One MIC.
For now i have set the sampling procedure with Sample Size as 5 for this MIC. But i have a problem here. If the inspection lot is less than 5 i.e 3 then we have only 3 Values to enter for the same MIC.
I have read in the other blogs regarding the Inspection Points, But i am not really sure how to use this, As the Inspection Point is maintained at the header level of inspection plan. how can this happen only for some MIC.
Appreciate your comments on above issue.