Message "No Objects selected" in planning book

[former_member406212]

Hello everyone!

I'm facing this message when I load a product in planning book, "No Objects selected"

I could see the product in //MAT1 & in //RRP3, RRP4 views but not in planning book.

I re-initialized the planning area, executed //OM17 & executed /SAPAPO/TS_LCM_CONS_CHECK.

Even after doing this, still the product is not getting loaded in planning book.

What could be the reason, Please help.

Thanks in Advance!

[Former Member · Accepted solution]

Hello Shaiz,

Try with t.code /SAPAPO/DM_PEGCHECK - consistency check for Pegging Area.

Is your planning book active?

Thanks, Marius

[former_member406212 · Accepted solution]

Hello Marius,

Thanks for the reply. yes the planning book is active.

I have check a product with similar attributes, and that material is loaded in PB but not the other one.

Thanks.

[Former Member · Accepted solution]

Hi Shaiz,

Please check if the product is in the active model 000!

Are you able to see it in the Supply Chain Engineer?

In the TSCONS did you have some errors (check the most recent log)?

Thanks, Marius

[former_member406212 · Accepted solution]

Hi Marius,

Yes the product is assigned to 000 model & no error in TSCONS as well.

thanks.

[marianoc · Accepted solution]

Hi,

Do you have this problem in one product or this happend for all the products?

Kind Regards,

Mariano

[Former Member · Accepted solution]

Hi Shaiz,

Please check LC TS for Master Data: t.code /SAPAPO/TSLCREORG

Also check in /SAPAPO/OM16, tab Peg.Area for conbination Planning version, Location, Product.

Thanks, Marius

[Former Member · Accepted solution]

Are you having some filter in your SNP object selection window?

[former_member406212 · Accepted solution]

Hello Marius,

I executed  /SAPAPO/TSLCREORG & /SAPAPO/OM16, both showed no errors, still I'm getting the same message.

No, there are no filters set in object selection window.

thanks.

[Former Member · Accepted solution]

Hi Shaiz,

Well, in this case I have a last idea. Delete the SKU and resend it again on APO side. Prior to this you have to delete the orders that were created for this SKU and all master data where this SKU is involved (use where use to find the objects).

A very good explanation in how to delete product is done by expert Dogboy in this link http://scn.sap.com/thread/1610739

You can also open a message to SAP support!

Thanks.

Regards, Marius

[former_member406212 · Accepted solution]

Hello Marius,

I got this out. SDP relevance in properties tab of //MAT1 was set to 1, hence it was not picked in PB.

Thanks one & all.

[jagannadhb]

Hi Shaiz,

Can you recheck your selection ID. If possible provide a screen shot. As a suggestion, use the 'Show' as Product-Location, since this is SNP.

Regards

JB