on 02-25-2015 3:44 PM
I'm trying to MOPZ my NW 740 SP8 EP system to SP9, but get this problem for all SP9 products (more than the screenshot shows)
LMDB is green, it is okey in SAP portal. I'm able to download SP9 directly i SWDC, so I guess my s-id should be okey for that SP.
Any ideas?
I am encountering almost the identical issue. I am using MOPZ to calculate an upgrade from NetWeaver 7.3 to 7.4 stack 9, and receive the same warning messages. I have updated my CR Content in SLD and verified that it has been synchronized with LMDB.
Note that if I select NetWeaver 7.4 Stack 8 as my target, the warning messages do not occur.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Modify your LMDB with SLD. It seems there are additional components in your LMDB. Check for diagnostic relevant flags, try to assign relevant netweaver product as diag. relevent.
These issues are related to LMDB data only.
Regards
Rishav
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Check in LMDB, Installed Component, assign Product.
Re-sync again.
Regards,
V Srinivasan
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
85 | |
10 | |
10 | |
9 | |
7 | |
6 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.