DDIC Activation errors during ACT_TRANS phase

[arsnlgunnr]

Hi,

I am currently upgrading to NW 7.4 SP09, ERP6 EHP7 SP07.  I am currently using the latest SUM tool (SUM 1.0/SP12/Patch8) and latest kernel 742 patch 28 with latest tp patch 38.  Other info:  WindowsServer 2008 R2, SQLServer2012

During the ACT_TRANS phase I am getting the following errors.  I have attempted adjusting the tp version in the kernel but still get activation errors.  I have also tried kernel version 742 patch 17 and still get errors.  Any help would be appreciated.  Thanks!

Errors from ACTUPG.elg file:

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

DDIC ACTIVATION ERRORS and RETURN CODE in H:\SP7_upgrade\SUM\abap\log\SAPA-10004INIAM.BPS

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

<NO ERROR LINES FOUND, BUT HIGHEST EXIT CODE WAS: "8">

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

DDIC ACTIVATION ERRORS and RETURN CODE in H:\SP7_upgrade\SUM\abap\log\SAPA-10006INPICM.BPS

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

<NO ERROR LINES FOUND, BUT HIGHEST EXIT CODE WAS: "8">

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

DDIC ACTIVATION ERRORS and RETURN CODE in H:\SP7_upgrade\SUM\abap\log\SAPA-61706INMDGAPPL.BPS

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

<NO ERROR LINES FOUND, BUT HIGHEST EXIT CODE WAS: "8">

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

DDIC ACTIVATION ERRORS and RETURN CODE in SAPA742EPU.BPS

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

1EEDO516X"Index" "SRAL_CONFIG_WD" "001" could not be activated

1 ETP111 exit code           : "8"

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

DDIC ACTIVATION ERRORS and RETURN CODE in H:\SP7_upgrade\SUM\abap\log\SAPAGPRD25.BPS

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

<NO ERROR LINES FOUND, BUT HIGHEST EXIT CODE WAS: "8">

[arsnlgunnr · Accepted solution]

Hi all,

I have fixed the issue,

Here was the error in the transport log for SAPK742EU:

I had to go into SE11 and remove the 001 index from table SRAL_CONFIG_WD.  After removing the 001 index and activating the table, the ACT_TRANS phase in the SUM tool completed successfully.

Thanks!

[former_member189501 · Accepted solution]

Hello Jayson ,

thanks for your help

I have the same problems and I solved like you said,

but the index to be delete is

SRAL_CONFIG_WD~UNQ not SRAL_CONFIG_WD~001

How said the note

2143587 - Index SRAL_CONFIG_WD~001 could not be activated

[former_member182657]

Thanks for sharing the solution & request you to kindly close the thread.

Regards,

[former_member182657]

Hi Jayson,

Could you share log for request SAPK742EPU ?

Regards,

[manumohandas82]

Yes . There is nothing here

Can you check whether any Dumps in the system ( ST22  ) and system logs ( sm21)

Thanks ,

Manu

[manumohandas82]

Hi Jayson ,

Can you attach the transport logs for any of the failed

SAPA-10004INIAM.BPS and SAPA-10006INPICM.BPS

Thanks ,

Manu

[arsnlgunnr]

Hi Manu,

logs are attached, but they do not show much error information...

SAPA-10006INPICM.BPS.txt.zip

SAPA-10005INIAM.BPS.txt.zip