on 02-23-2015 10:32 AM
Hello QM-Gurus,
I have a Question.
I have created a Sampling Procedure with the requirement 100 % measured and 90 % must be correct.
Than I have created an Inspection characteristic with following keys:
In the inspection plan I have assigned this inspection characteristic with the sampling procedure:
After the inspection lot is created I go to QE51n and input the measured values.
I expected that after these entries automatically valued, but it will always be displayed manual review.
Why is that?
The other inspection characteristics are evaluated automatically.
Best regards
Ulrike
Hi Ulrike,
I believe the result added at 6th position as 0,19 is beyond the MIC tolerance range (0,00 - 0,18) and so that particular individual result valuation is coming as "Reject". But this valuation is not final until operation level valuation is done to get the status form "2" to "3". There you should get the standard SAP Popup (or default valuation) as "Accept" as one faulty record is well within the acceptable limits of the Sampling Procedure used.
Please can you go back to the operation level valuation and suggest what is the default popup there? Please attach that screenshot too.
Please check and feedback,
Arijit
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.