idoc error with bd87 in SRM

[Former Member]

Hello,

I have tried to launch some idocs in status 30 with the transaction BD87 in SRM and now the status is 02 due to this error:

Function module ZSR_GB_I_IDOC_P1_ARIBA_PROXY is not RFC-compatible

Message no. E0035

Diagnosis

Function module ZSR_GB_I_IDOC_P1_ARIBA_PROXY, which should assume
reponsibility for further IDoc processing, has been stored for port
SRM_XI_P1.

Such function modules must support Remote Function Call. However, function
module ZSR_GB_I_IDOC_P1_ARIBA_PROXY does not have this attribute. As a result,
this IDoc could not be processed further.

Procedure

Please change the attributes of function module ZSR_GB_I_IDOC_P1_ARIBA_PROXY
or enter an RFC-compatible function module in the port definition for port
SRM_XI_P1.

These idocs contain the items of a shopping cart. The line item 1 was sent properly without run the idoc by BD87.

Thank you.

Best regards.

   
 
 
 
 
 
 
 
 
 
 
 

[ivy_li]

Hi,

Would  you please check if 'remote-enabled mode' is ticked in attribute tab for this Z-function module(trx se37)?
If not, please tick it and check if this error still persists.

BR,
Ivy

[Former Member]

Hello Ivy,

it is not ticked, but this error is raised only for some idocs. Others have been run properly with the same message, interlocutor and destination.

Thank you.

[ivy_li]

Hi,

This is a Z-FM module, so I am not aware of its usage.

But from my understanding, some FMs needs to be used in the RFC call, so RFC-enabled is required.
The solution in the popup message is clear:
===

Please change the attributes of function module ZSR_GB_I_IDOC_P1_ARIBA_PROXY

or enter an RFC-compatible function module in the port definition for port

SRM_XI_P1
===

If this is a FM defined in ECC side, it will be called from SRM. So it should be remote enabled.

Best regards,

Ivy