Exit to change the Product/Location Substitution based on check Horizon

[Former Member]

Hi,

Can you please let us know a User Exit or Badi which would satisfy the below requirement.

- If the configuration is maintained as Confirmation  at checking Horizon in ATP Check Control it happens like it would check for the stock available in the plant given in Order creation screen and display the remaining stock with the date available.

-Requirement is instead of displaying the date available for the stock it should check in the plants of the Rule and display the avaialable stock from them.

To enhance the same can you please let us know if there is any Exit avaialable for the same.

[Former Member · Accepted solution]

Hi,

You would not need any enhancement here, this is standard GATP Functionality, where you not able to acheive this after maintaining the Rules for product or location substitution? let us know how you have setup the system for RBA.

[Former Member · Accepted solution]

Hi,

By maintaining the Rules for Product and location substitution we are able to fetch the requirement in case if ATP Check Control is maintained as END of check Without confirmation at check horizon.

But when it is maintained as Confirmation at check horizon the output derived by Rules is being over written in teh function module /SAPAPO/DM_ATP2_CHECK.

Please mention incase of any Exit or enhancement available for the same.

[Former Member · Accepted solution]

Hi,

please check this thread.

[Former Member · Accepted solution]

Hi,

Could you take a screenshot of your Rule control it will help.

There are also some other thread which says about using calculation profile " allowed Delay"

[Former Member · Accepted solution]

Hi Rorie,

It's location substitution only and the list works forward from input.

Can you please let us knwo incase of any enhancement for it.

[Former Member · Accepted solution]

Hi Silpa,

Iam not aware of any enhancement, but i think the solution lies in your calculation profile, "allowed Delay" - can you test with 0 and >0 , also presuming that you have populated your checking horizon in the ATP Tab page of the material master