on 02-10-2015 12:43 PM
hi,
i have an ico configured in ID which is proxy to soap scenario. we are using Soapsender_AAE in sender communication channel.
we have configured everything in SXMSIF and SXMB_ADM. still we are getting the below mentioned error in SXMB_MONI:-
</SAP:Error>
please suggest somrthing i have read many blogs bt not getting any solution
Thanks
Sandhya
Hi Sandhya,
Glad to know that the issue was resolved. However please clarify what was teh resolution. Whats RCC? Receiver comm channel?
Also please close the thread if there are no issues.
Regards,
Sriram
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
thank u everyone for your help
the issue was resolved .
i just inactivated and then again activated RCC.
Thanks
Sandhya
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Sandhya,
Please remove ICO once and create it again.
Hope this helps.
thanks and regards,
Praveen t
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Sandhya,
This is a case of no receiver could be determined..Can you check if there are any conditions in your ICO for determing receiver? Also does your payload satisfy the requirement.
Also cross check if the interface details in ESR and ID are referred correctly
Will be great if youcan give screen shot of the message in error and your config screen shot.
Regards,
Sriram
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Sandhya,
Are checking the error in SXI_MONITOR in ECC or PI if you created ICO then the message should go to adapter engine not ABAP stack of PI, if the message reach to PI ABAP stack and giving no receiver error then it should be problem with SXMB_ADM config, please double check service, interface name and namespace in SXMSIF, some times there will be typo errors.
Regards,
Praveen.
Hi Sandhya,
Please check if you have mentioned the interface names and other stuff correctly as mentioned by Iñaki Vila
Also you shouldnt test the configuration in ID if its making use of AAE.
Regards,
Sriram
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
88 | |
10 | |
10 | |
9 | |
7 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.