on 02-05-2015 7:00 PM
Hi All,
I have configured many sender and receiver jms communication channels. Some times WS-MQ is down and not running properly so all PI channels are getting error. To overcome this case I have used "create connection on demand" setting in receiver jms communication channels. so receiver channels are not getting connection issues. There is no such option is available to sender jms adapter. So we are getting connection errors if WS-MQ is down. Later even if, WS-MQ is up and running fine also automatic connection is not established by sender jms channels. In this case we should stop and start manually all sender channels. Is there any setting to overcome manual stop and start activity? or automatic reconnection?
Regards,
Ashok.
Hi Ashok,
Please check below Note question 14
1086303 - XI JMS Adapter and IBM Websphere MQ FAQ
Regards,
Praveen.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
if message listener based connector option is not available you can try "message Poll job"
Refer the note -1501724 - JMS Adapter multiple listeners registered with EOIO QoS
1568551 - JMS Sender channel with message poll job - stops polling
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Ashok,
Check the option "Use Message Listener based Connector" for Sender JMS channel your issue should be resolved.
Regards,
Pranav
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
86 | |
10 | |
10 | |
9 | |
6 | |
6 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.