request for not displaying Quality Inspection Stock in md04

[Former Member]

Dear,

The planners’ request is to take into account the Quality Inspection Stock during the MRP run, (as in standard) but not to display the stock in the md04 screen.  (so subtract the Quality Inspection Stock Qty to the total stock Quantity. )

I found this requirement was strange in a sense that the mrp result were not in line with the display of the qties in the md04 screen.

Anyway, would you think this might be feasible with badi ‘MD_DISPLAY_ELEMENT’ ?

(btw: In the selection rule that we use ‘Selection of QM inspection lots’ is set to be on ‘do not consider’ and still these are taken into account., do you also a comment on this?)

Best regards,

Frederik

[raviraj_sharma · Accepted solution]

Hey,

Check the below thread , might be useful:

[Caetano · Accepted solution]

Hello Frederik

Please take a look on my answer on the thread previously refered. If you want to implement BAdI MD_CHANGE_MRP_DATA to solve the issue, the following document may be useful:

Regards

Caetano

[Former Member · Accepted solution]

Thanks both for your answers,

regards,

Frederik

[Caetano · Accepted solution]

Hello

If your question has been answered, please close this thread.

See the link below:

Regards

Caetano

[Former Member]

Hi,

Thanks for this interesting post, but this does still not seem to cover the requirement as described above.

There is no change possible of the total stock data with the suugested Badi(s) ...

Also, only the display of the total stock should change (substracted with the quallity inspection stock), but the quality inspection lot should still be considered in the MRP run...

Thanks for your help,

Frederik

[Caetano]

Hi Frederik

You can manipulate the stock with the method CHANGE_MDPSX_MARD of BAdI MD_CHANGE_MRP_DATA. You will be able to exclude the qualityt stock and it will not affect the inspection lots.

Regards

Caetano