on 01-22-2015 5:04 PM
Hi all,
I am very new to GRC. We have FF logs setup. We run GRAC_SPM_LOG_SYNC_UPDATE in batch every 30mins to start the workflows. The batch program failed to run and we have entries in table GRACFFLOG that are not picked up when batch job was re-started.
Question, how do I get these older entries processed? Some Administrator t-code, prg, ? I see a prg for 10.1 but not in 10.0.
Thanks.
Rick
Ver 10.0 sp13
Hi Rick,
did you check the following note?
http://service.sap.com/sap/support/notes/1934127
Be careful with this tool as wrongly used it might end with inconsistencies.
Let us know.
Regards,
Alessandro
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.