Plant Specific "Selected Set" as UD - QA32

[Former Member]

Hello Experts, Please help me to find the correct method to assigning Plant Specific UD Case – In transaction QA32 system is showing all Non relevant UD code, which leads to increase confusion for End user. Configuration Setting I have done & tested also are - Using Transaction QS51 I have assigned Plant specific “Selected Set” and deleted Non relevant Selected sets. Also, I have assigned the same “Selected Set” in Plant-Dependent QM Settings --> Result recording --> Proposal for inspection point valuation. But still all the UD codes are coming in QA32. Please help find the correct settings, Thanks in advance!!

[former_member42743 · Accepted solution]

Assign the selected set in the inspection type set up in configuration.

QM-->Quality Inspection-->Inspection Lot Creation-->Maintain Inspection Types

Make sure selected set in own plant is ticked on.

Then create a copy of the selected set in each plant.

Craig

[Former Member · Accepted solution]

Thanks Craig, It is woking fine Discussion Closed