Material Specification

[Former Member]

Hi QM Superiors,

I have a doubt regarding Material specification - QS61,

Doubt 1- Is material specification is maintained at client level..?

Doubt 2- What are the pre-requisites to perform qs61..?

Please clear the doubts and thanks for the same

Regards,

Santosh

[nitin_jinagal · Accepted solution]

In addition,

You also need to maintain the MIC as Complete copy model or the referenced one to get it assigned to material specification. Incomplete MICs cannot be used in material specs.

Moreover, any transaction where you don't give plant as 'input' are client specific and accordingly maintained.

ntn

[busyaban7 · Accepted solution]

One more point.

In 'Plant-Dependent QM Settings' configuration, you should NOT activate the checkbox 'batch valuation without material spec' under inspection lot completion tab.

Thanks,

Arijit

[Former Member · Accepted solution]

Thanks for valuable response.

[Former Member · Accepted solution]

Thanks you nitin

[nitin_jinagal · Accepted solution]

Hi,

After final per-requisite given by Arijit, I don't think there's more left. You may kindly close this thread. Don't leave this open.

ntn

[busyaban7 · Accepted solution]

Hi Nitin et al;

This is one of the great threads to participate on. Thanks for your inputs

Arijit

[former_member190267]

Hello,

Material specs are created for a material that can be used for all the plants.

This means it is created at client level.

Regards,

Natália

[Former Member]

Thank you natalia for your valuable answer

[former_member201849]

Hi Santosh

1. We wont maintain Material Specification at Client Level.

    Material can be inspected in two ways.

            (1) Inspection with Task List

            (2) Inspection with Material Specification

2. Pre-requisites for Material Specification

            (1) Create Material in MM01

                (2) Create MIC's in QS21

                (3) Create Material specification in QS61 ,assign MIC's in Material specs.

                (4) In Material Master active QM view -->inspection type--> check material specs

                (5) Create Inspection lot & Material specs will get assign to the Inspection lot as a Inspection plan.

                (6) Do RR, & take UD.

Regards

SURESH.M

[Martin_H]

Your statement concerning 1 is wrong: Material Specifications are maintained at client level.

MH

[Former Member]

Thanks for your reply