Change Inspection Setup Settings

[Former Member]

Hi,

I want to change some Inspection Setup settings...as shown below image...

in Red Color circle, 3 check boxes already selected....

I want to Remove these checkboxes from Configuration...because they are coming in Mass Change thru QA08 automatically.

Regards.

[former_member42743 · Accepted solution]

Did you see the node in configuration called "Define Default Values for Inspection Type" ?

You set these to be what you want.

In QA08 you can check or uncheck any settings you want to when running the transaction.  You don't HAVE to use what the system proposes.

Craig

[ferran_mateohidalgo]

Hi Anil,

These values are according to parameters taht you have in the customizing for each inspection type.

SPRO -> Quality management -> Quality Inspection -> Inspection Lot Creation -> Define Default Values for Inspection Type.

If you want to change this setting wheneverthat you assign a inspection type in one material will be assigned by default the set values. But no changes in the material that have assigned the inspection type