on 01-09-2015 5:01 AM
Hi Everyone,
I have issue on SPROXY ESR connection for new SAP SYSTEM.
1) RFC Connection are fine both PI and new SAP system.
2) SLDCHECK and SXMB_ADM connection are good.
3) SXI_Cache and SICF everything is fine.
Still I am unable to see the ESR in SAP system. Could you please help me on connection issue.
Thanks
Ashok
Hi Ashok,
Create a G-Type RFC connection in ECC system.
Path Prefix: /rep
Target host and Service No. should point to PI System.
Pradeep
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
hi Ashok,
Please confirm if you have done all the steps mentioned.
and after that Please run these reports to check the issue.
1)
The address of the Integration Builder must be stored in the R/3 System
=>Check/maintain with report SPROX_CHECK_IFR_ADDRESS
The address is taken the from following parameters in the exchange profile (section 'connections'):
2)
The HTTP connection of the R/3 application server must function correctly
=>Check with report SPROX_CHECK_HTTP_COMMUNICATION
3)
The Integration Builder server must be running correctly
=>Check with report SPROX_CHECK_IFR_RESPONSE
similar issue addressed in below link
hope this helps.
thanks and regards,
Praveen T
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
82 | |
10 | |
10 | |
9 | |
6 | |
6 | |
5 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.