Measurement Point holding Upper Limit

[Former Member]

Hi,

We have a measuring point which had a upper limit, but we have removed it . System still prompts with the warning message that the reading above the upper limit. Can anyone suggest regarding this or if tehre are any notes?

Thanks,

SP

[jogeswararao_kavala · Accepted solution]

Hello S P,

Because this is not the standard behaviour, you need to give the message screen you are getting and Range value screen, where you are putting this value.

[Former Member · Accepted solution]

Hello Jogeshwara,

Here are the screenshots requested -

Thanks,

SP

[jogeswararao_kavala · Accepted solution]

Hello  S P,

I understood the problem. It is simple. You do this.

1. Go to IK02 --> Go to Addl Data.. screen (Range value screen). Just remove the Zeros also (Erase) from the Range value screen and press Enter.

2. You are out of the pop-up now. Save the measuring point.

Next time when you go to this screen it looks like this:

After this, you will not get the warning message. What is happening now is that the system is considering the 0,00 value also as a value. So, any value in the Counter Reading of IK11, is giving rise to a warning.

KJogeswaraRao

[Former Member · Accepted solution]

Thanks Jogeswara. It works fine now.

Thanks,

SP

[MTerence]

Hi S P,

When you provide screenshots, kindly provide the SAP version you are using.

On checking OSS Notes, only it is valid for version 470.

Regards

Terence

[Former Member]

hi ,

Greetings

kindly share error screen shot.