cancel
Showing results for 
Search instead for 
Did you mean: 

Error: IDOC_ERROR_METADATA_UNAVAILABLE

Former Member
0 Kudos

Hi Everybody,

I need experts advice for receiving  custom IDOCS from ECC4.6 to PI 7.4 single stack Java.

Issue: we have one scenario, where my sender system is ECC 4.6 is sending custom IDOC to PI 7.4 but unfortunately PI is unable to receive the same and it got stuck in sender ECC (It is an legacy UNICODE system) SM58 with error "IDOC_ERROR_METADATA_UNAVAILABLE". where as PI able to receive standard IDOC from the same system.

Even when we checked in NWA logs  & errors showing the same  error like " IDOC_ERROR_METADATA_UNAVAILABLE".

We checked have reimported the meta data and refreshed the cache even though getting the same error and also we have implemented notes 1767710 ,1473183 ,1529038 & 1405466 but there is no use.

Am very much thankful to every one who can contribute to resolve the same.

Regards,

Chandu 🙂

Accepted Solutions (0)

Answers (3)

Answers (3)

dipen_pandya
Contributor
0 Kudos

Hi,

At ECC side idoc would probably stuck in tRFC in your case.

Try to resend idoc from WE19.

But AFAIK it could be an authorization issue.

Regards,

Dipen.

Former Member
0 Kudos

Hi,

Sometimes this can be related to authorisation issue. Please check.

Message was edited by: Leela Morampudi

Former Member
0 Kudos

Hi Leela,

We are receiving standard IDOC with using the same authorization but we are facing this issue only for custom IDOCs only.

Rgds,

Chandu 🙂

Former Member
0 Kudos

Hi Chandu,

If issue is with custome IDOC's then surly the issue may be with one of the above mentioned points by me. plz check settings again in ECC

Regards,Prasanth

Former Member
0 Kudos

Hi Prashanth,

we have checked again which you said above, still we are facing the issue.

Rgds,

Chandu :-).

Former Member
0 Kudos

Please check RFC destination used in the IDX1 port is set the option Unicode (Unicode Tab) in PI.

regards

swanand

Former Member
0 Kudos

Hi,

If issue not solved. Try

1. get IDO Cnumber from message failed in SM58. then delete entry in sm58 and try to resend IDOC from we19. (if IDOC status is Green)

2. Some time this issue may occur in consistent SLD entries. like

the Business system may not have the software component related to your IDOC configuration.

So check the sender tab of business system in ID. will it has your IDOC is in outbound interafces list.

if not check SLD --> Busienss system-->installed software

Reagrds,

Prasanth


Former Member
0 Kudos


Hello,

Check IDOC sements are released properly in ECC

also if extension exist for IDOC, check that extension was mentioned/linked correctly with basic type.

Reagrds,Prasanth

Former Member
0 Kudos

Hi Prasanth,

We have checked the data and all the segments were released properly in ECC and Extesion is also maintained correctly.

Rgds,

Chandu 🙂

Former Member
0 Kudos

Hi Chandu,

what is the IDOC type that you are Using.

Did you tried to register metadata manually in PO - IDOC metadata monitor?

plz also check IDOC extension is

linked with basic type (Display IDOC types--> extension Attributes)?