on 10-31-2014 3:37 AM
While trying inspection instruction print in QA02 i am facing issue as below mentioned, i already configured required setting like spool parameter for user and printer specification and also output device in spool ( User profile ) can any body know where was the settings missed.
No printout required or no print information available
Message no. QE578
Diagnosis
The shop papers for the inspection lot (sample-drawing instruction and/or inspection instruction) are not printed as determined by the QM print control in the output controller.
System Response
There is no print output.
Procedure
Check that the print control is set properly. If necessary, check the settings for the inspection type and deactivate the immediate output of the sample-drawing instruction and/or the inspection instruction.
Gururs,
While trying QA02 I am facing issue
Did you check the control indicators on the master inspection characteristics? There is a print control indicator on the second page of control indicators.
The options are
- Do not print
- Do not print at skip
You might have them all set as "Do not print"
Craig
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
107 | |
12 | |
11 | |
6 | |
5 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.