Parameterized Message Mappings in ICO in PI 7.4

[Former Member]

Hi Experts,

As new version of PI support for Parameterized Message Mappings in ICO; can anyone elaborate as to how Parameterized Message Mappings is used in PI 7.4 single stack by using Integrated Configuration Object.?

Thanks & Regards,

Rahul More

[Former Member · Accepted solution]

Hi All,

Thanks for the reply.

I know about parameterized mapping in 7.1 just wanted to know the change at ID side in PI 7.4.

Can you post the screenshot of ICO part where you mention the parameters as i am not having the access to PI7.4 but wanted to know about it.

Thanks & Regards,

Rahul More

[former_member184720 · Accepted solution]

If you open ICo then you should be able to see receiver interface tab where you should configure the parameter.

[Former Member · Accepted solution]

Thanks a lot Hareesh.....

[azharshaikh]

This message was moderated.

[former_member184720]

It is supported from >7.31(Ico)

Did you check the below blog..

During the configuration, you need to configure the values under Receiver interface tab.