on 10-14-2014 5:55 PM
Hello Experts,
I have a requirement of integerating my WDA applciation to a WorkFlow task .
By this whenever a workitem for the respecitve task is created , it should be linked with my WDA Application.
Now when the user clicks on a workitem my WDA applcation should be running.
I ahve checked with below links and im still not getting my WDA applciation opening on click of WI.
Instead it runs for a while and goes to error state.
Error in task - 'EXCEPTION 9001'
Hi Vignesh,
What application a work-item should use at runtime is defined in the Task Handler.
Assuming you are using a custom workflow class with a dummy method, you will need to maintain the task visualization ( TCODE = SWFVISU ).
In the task visualization maintain application name = <Your WDA name> like so,
The WI_ID=${item.externalID} passes the key to the workflow when the user executes the work-item.
-
Linkin Pereira
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Linkin,
Thanks for the response but as i have mentioned i followed the steps mentioned in the links which i referred in my post.
Either wise i tried this at first but it dint work.... But tell me one thing i dint not give Configuration and Alias Name in that visualization parameters. Does that matter ?
Hello Vignesh,
Configuration Name is for the application to know how to render the view, so I guess it not necessary, but doesn't harm to try so give it a shot.
Alias Name is basically the portal alias name on the system so its not necessary either.
What I suspect is there could be an issue in the way your task is working.
Try some of these suggestions incase you haven't already :
1. Look in the workflow log for any hints on the source of the error.
2. Try executing your WDA as a stand-alone application
3. Put a break-point in the WD_INIT method, simulate the task using SWUS and see if your WDA is actually getting called.
4. Look in ST22 for any dumps.
5. Look in SU53 for any authorization issues.
I hope you find a clue or a hook for us to investigate further.
Apart from the basic SWFVISU config that I have specified in my initial response, I haven't done any additional configuration to bind my custom WDA to a custom workflow task I created.
--
Linkin Pereira
The solution depends on what inbox you are using.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
87 | |
10 | |
10 | |
10 | |
7 | |
6 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.