MSMP workflows do not get saved in GRFNMW_CONFIGURE,

[Former Member]

My MSMP workflows do not get saved in GRFNMW_CONFIGURE, since i started saving workflows in GRFNMW_CONFIGURE. Could you suggest, how can i again start/resume creating workflows in MSMP(UI)

[Colleen · Accepted solution]

Hi Plaban

your question makes no sense. What issue are you having in MSMP? Please include a screen shot to explain your situation.

Starting a workflow is different to configuring on.

Regards

Colleen

[Former Member · Accepted solution]

Hi Colleen,

workflows configured through UI(SPRO->...->Maintain MSMP workflow), does not reflect in t-code GRFNMW_CONFIGURE., while the vice-versa does.

This has started since, i did 1 configuration through GRFNMW_CONFIGURE.

How to go back to workflow config. through UI

[Colleen · Accepted solution]

If you went into expert mode and corrupted your msmp config, I recommend you reapply the bc sets and replace (reset it). Take Prasant's advise and use the standard way (webdynpro screen)

any more assistance on this question and you will need screen shots as it's a bit confusing with what you are asking

[Former Member · Accepted solution]

Did you activate the saved workflow? it seems you are having a hard time figuring out how to configure in MSMP. Have you tried following the guides and documents shared on this forum?

[former_member193066]

tcode GRFNMW_CONFIGURE_WD or use SPRO>GRC>AC>Workflow for AC>maintain MSMP

dont try expert mode unless you understand the logic and utilization clearly.

Prasant