Invalid Program Name; Program must contain prefix "_SLD_"

[harish_babu5]

Hi

I was following this blog and trying to create a TS for my R/3 system.

I click on the icon "Start Data Collection now " and I get this error: "Invalid Program Name; Program must contain prefix"_SLD_"

I see that already a background job is running, but that has been running from fiday, more than 720 minutes.

Any idea I am getting this error. Mine is a very new ECC system, and I haven't done any settings related to PI. I am using PI 7.4, single stack, also called PO 7.4

Regards

Harish

[patelyogesh · Accepted solution]

Hello,

Do you have RFC in SM59 called SLD_UC and  SLD_NUC?

-Yogesh

[harish_babu5 · Accepted solution]

Yeah, both these RFC s are there and I did connection test as well for both

They are working

Regards

Harish

[Former Member · Accepted solution]

Hi Harish,

In RZ70 select all entries in the screen (you will find below of rz70 screen) ,then save and execute .

If it still gives the error then remove SLD_UC from SM59, and execute again in RZ70 ,SLD_UC
Will create automatically.

Thanks,

PrakashReddy

[harish_babu5 · Accepted solution]

Hi Prakash,

I want to cross check the details I have entered:

I see a tab RFC Connection to Host

Under that I see Gateway Host and Gateway service.

Whee should I find the values entered here?  I want it to be correct

Can you tell me where to check?

Regards

[harish_babu5]

Hi

I just noted tht SLDAPICUST is not configured in my R/s system.

Could that be the cause of error? Also SLDCHECK fails. There is no Business sytem and technical system created in SLD for this ECC system.

What is the order in which these transactions should be done?

Do I have to configure SLDAPICUST before creating TS and BS for R/3 in SLD?

Regards

[patelyogesh]

Hello Harish,

Please setup SLDAPICUST.

Make sure Aloas Name is same for all systems in your landscape pointing to one SLD.

I do not think this is require to collect/send deta to SLD through RZ70

Regards,

Yogesh

[divyanshu_srivastava3]

Hi Harish,

What is the ECC system release and SP level ?

What do the job logs says about these jobs ?

Regards,

[Former Member]

Hi Harish,

Please check the following note:

907729 - RZ70: Termination of the SLD data supplier

Thanks

Adil

[harish_babu5]

ECC system release 740 and SP is 006

[divyanshu_srivastava3]

Hi Harish,

Run SLDCHECK, and where ever it fails, work on that part.

Once you have fixed those issue, SLD will be opened from SLDCHECK.

Also, refer:

Regards,

[former_member185239]

Hi Harish,

There will be around 11 to 12 program which are used to transfer the data to SLD.

In Se38 , looks for the program starting with _SLD_ and checked there status.

Also do let us know the kernel release for ECC system and version of ECC.

ST-A/PI and ST-PI release and SP level

With Regards

Ashutosh Chaturvedi

[harish_babu5]

Hi Ashutosh,

Kernel Release is 741.The Service Pack is 006, release 740

ST-PI 2008_1_710

SE38, I saw programs. What status should I check? When I click on check it said, program is syntatcally correct.

Regards

Harish