cancel
Showing results for 
Search instead for 
Did you mean: 

SLT Replication in Scheduled status

former_member185165
Active Participant
0 Kudos

Hi All,

I have created a configuration to using LTR, to replicate tables from ABAP source to HANA.

But I see all of the table replication status as scheduled since few hours.

However DD08L is executed and DD2L and DD02T are in process.

Could you please help me on this?

Thanks & Regaards,

Vijay

Accepted Solutions (0)

Answers (1)

Answers (1)

Former Member
0 Kudos

Vijay,

You should start replication of all your application tables once all the DD* tables are in Delta Mode..

Regards,

Joydeep.

former_member185165
Active Participant
0 Kudos

Hi Joydeep,

Thanks for your time and answering me.

Could you please elaborate more on this.

How to detect the tables in Delta mode status?

I started the replication of other tables like BSEG, BKPF after DD08L was executed and DD2L and DD02T were in process.

I also had started the replication of DD07T and DD07L along with BSEG and BKPF.

You mean to say, I should wait first load DD07t and DD07L and after that BSEG and other tables?

Thanks & Regards,
Vijay

former_member185165
Active Participant
0 Kudos

Hi All,

I deleted the configuration and created now. Now even DD08L, DD02L and DD02T are in scheduled status.

Someone can help me on this ?

Thanks & Regards,

Vijay

former_member185165
Active Participant
0 Kudos

Can someone help me on this in the group?

Regards,

Vijay

Former Member
0 Kudos

Vijay- Can you please tell me what is the Trigger Status?Is Logging table created for these tables?Also what is the processing option for these tables?Check all these through tcode LTRC in SLT.

former_member185165
Active Participant
0 Kudos

Hi Joydeep,

The triggers are not getting created in source system.

This may be again due the user _SYS_DATAPROV getting deactivated in HANA.

Thanks & Regards,

Vijay

Former Member
0 Kudos

Vijay,

Have you checked in SLT--DBCO connection working fine or not..

Please check it as I doubt whether it is working or not.

former_member185165
Active Participant
0 Kudos

Hi Joydeep,

All the connections are working fine.

RFC to the source and DBCON connection to SAP HANA, these are working fine.

No issues with these. If there was problem with connection then I would not be able to proceed and complete with creation of configuration. Since the connection is fine, the schema is also created in SAP HANA with the name of the configuration.

Thanks & Regards,

Vijay

Saritha_K
Contributor
0 Kudos

Hi Vijay,

Are you still facing any issues with the new configuration?

Regards,

Saritha

former_member185165
Active Participant
0 Kudos

Hi Saritha,

Yes. Its still the same.

Thanks & Regards,

Vijay

Saritha_K
Contributor
0 Kudos

Hi Vijay,

Can you please check the application logs tab using LTRC T-code, and also execute t-codes SM21 and ST22 to see if there are any error messages reported on the system (In both source and SLT system if they exist on two different systems..)

Regards,

Saritha

former_member185165
Active Participant
0 Kudos

Hi Saritha,

i cannot find anything there.

In HANA I can see that _SYS_DATAPROV is deactivated.

Is it because of that?

Thanks &Regards,

Vijay