on 09-20-2014 12:36 PM
Hi All,
I have configured ECC as a Connector, and a FF id with below roles, in ECC. After Repository Sync, the table GRACUSER, shows FF id from ECC. However, while assinging Owner to FF id, the FF id from ECC, is not shown.
SAP_GRAC_SPM_FFID
SAP_GRC_FN_BASE
SAP_GRC_FN_BUSINESS_USER
Any clue, what needs to be done here
HI Plaban
What is your configuration parameter 4010 role? Is that role assigned to the FF Id (before you ran the sync)?
Did you set the owner up as an Access Control Owner first?
Have you checked to ensure you have sufficient authorization GRC to assign the FF Id?
Regards
Colleen
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Plaban,
Check below :
1> User is service user
2>Run Authorization Sync
Thanks,
Mamoon
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
15 | |
4 | |
2 | |
1 | |
1 | |
1 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.