on 09-03-2014 12:56 PM
Hi,
Inspection lot not getting created after GR is done.
The scenario is Storage location is connected to external warehouse management,so after the GR is done in the legacy system via interface it is updated in ECC.so while checking the material document inpection lot is not created.
Can anyone please tell me the necesaary check points and integeration steps between WM and QM in this case .
Thanks in advance.......
Hello Ajeya
Conditions to activate quality inspections are: MM movement type must be QM relevant and material must be inspection type activated.
Regards
CD
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello,
For inspection lot creation you need to activate inspection type in MM- QM view.
Regards
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Since you didn't say much, I assume you are creating stock into ECC via LSMW using 561 movement. Now to get inspection lot for these batches/ docs, you need to activate inspection type 05.
Go to material master QM view, assign and activate inspection type 05.
Additionally, create a respective inspection plan/ task list for the material(s) to carry out RR and get the consistent inspection lots.
ntn
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
107 | |
12 | |
11 | |
6 | |
5 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.