BPA - Measured Value = '0'

[Former Member]

Good Morning Experts

Please can someone provide guidance on the following problem:

i have a Idoc Monitoring object configure for a selection of Vendors

when i run the BPA i get mesaured values of ZERO for some of the Partner Number

how can exclude these entries

Thank you

[Former Member]

hi

have you checked the filter options on top

Thanks

Jansi

[Former Member]

Hi Jansi

yes i did read that blog but i think that is not my problem

my issue is that before i can even set the filter i have vendors with measure values = 0

i would imagine there is a  way the when i perform the 'Apply Timeframe' button and then perform te 'start analysis for the selected key figure' the values for the selection criteria are return

note that i have not selected the Chart dimesnions filters yet

its anylsis is returning measure values which 0 as part of the return

[volker_vongloeden]

Hello

the zeros indicate that those partners had some value greater than zero somewhere in the past but now they are down to zero. These zeros are stored on purpose so that you can have a Trend Analysis without gaps.

Kind Regards

Volker