Using table rate with scale in transportation zone

[Former Member]

Hi Experts,

I have a question with using a rate table and scale in transportation zone.

I need a scenario of calculation sheet with rate table using a transportation zone scale. In my freight order, i have many freight unit of different destinations (many locations).

I configure this scenario, but the system does not use the transportation zone with select price on table rate.

Help me.

[Former Member · Accepted solution]

Hi experts,

Well, my question is resolved. The system using a scale based on transportation zone.

The visual information is not possible really, because can exist many zones to location.

The system using this information but not show it in FO.

To run tests you will see that the system will calculate correctly.

Thanks for all,

Marcio.

[Former Member · Accepted solution]

Great Marcio! thanks for the feedback!

[tarunkumar]

Hi Marcio,

You have not given any details of your rate table, just by looking at calculation rule tab of order it's not possible what is the problem.

Secondly, text is not in English; If column positions are not interchanged then in your case system is not able to pick a DATA SOURCE VALUE. which means ZONE evaluation is not done properly for your locations.

You have to share more details in English.

Thanks & Regards,

Tarun Kumar

[Former Member]

Hi Tarun Kumar,

well, go to more details.

I have a freight order with two stages.

My calculation costs is based on stage condition (FRT_PEDIDO).

My configuration for this scenario is:

1. )    Calculation Sheet

1. )    Rate Table

1. )    Config to condition

1. )    Master data to Transportation Zone

1. )    Locations included in transportation Zones

1. )    transportation Lane

location “PLC_SBC_014” is my plant and “Z_SP_SUL” is my transportation zone.

“Z_SP_SUL” is the transportation zone and “0……021” is customer location 1.

“Z_SP_SUL” is the transportation zone and “0……063” is customer location 2.

[Former Member]

Hello Marcio,

Just a question: why you are using the calculation base condition in the charge type?

Have you tried to test with only one FU and zone?

Best Regards, Marcelo

[Former Member]

hello Lauria,

I test with only one FU and the result was the same.

good, as the calculation base condition was made by another person, I don´t modify in the initial time. Have you indication to change it on this scenario?

Best regards,

Marcio.

[Former Member]

Hello Marcio,

Well, my question was only to know the reason...

What I would recommend is try to create the smallest scenario possible in a way to discard posssibilities, do you know what I mean?

Maybe the log of the charge calculation could help more...

Best Regards, Marcelo

[Former Member]

Hello Marcelo,

I test again the scenario, but I modify the configuration in the calculation base condition in the charge type. Now it´s initial.

The result is the same.

I don´t believe this is influencing the result.

I still believe it's a problem of search in the price table. It´s a problem of system.

I will open a incident on SAP.

Thanks for your attention,

Marcio.