Solman SMD Agent Status say Not connected

[Former Member]

Dear All

Slman smd Agen Show not connected

Nainesh

9376998808

[former_member206167 · Accepted solution]

Hi check note 1626853 to force agent FQDN and ip address, also check in SLD that your Diagnostic Agent is registered.

Kind Regards

[Former Member · Accepted solution]

Dear All

My Problem is solved now

For any DAA agent coneectivity  isssu first run below commend when u run scrip

smdsetup supportlogs

this give all log and connection port also and then run releted script then problem solved

Thanks to all for support me

nainesh

9376998808

[MichaelFoley]

Hi Nainesh,

There are a lot of helpful instructions on note 2046931.

Have a look and see if this helps?

Kind Regards

Michael

[Former Member]

Dear

I attech on Zipfilie name:SMDAgent.ttxt.zip

pl down load and chek

nainesh

[divyanshu_srivastava3]

Hi Nainesh,

Can you provide the screenshot ?

Did you check the logs ?

Please provide screen shot from agent admin

Divyanshu

[Former Member]

[divyanshu_srivastava3]

Hi Nainesh,

Can you 1st start your agent ?

Goto user DAAADM and issue "startsap SMDAXX" command, where XX is you agent's instance number like 97 or 98.

Regards,

Divyanshu

[Former Member]

Dear

It Window system in om Sap Managment Consol All Are green

but j2proces are yello i send screen short after restart same result

nainesh

[divyanshu_srivastava3]

Hi Nainesh,

Please check FAQ - Diagnostics Agents - Solution Manager - SCN Wiki

You will get logs and details.

Have a look at  SMDSystem.X.log  SMDAgentApplication.X.log

and share it.

Regards,

Divyanshu

[Former Member]

Dear

I gent SMDSystem.X.log  file  it is attech now pl check

nainesh

SMDSystem.0.log.TXT.zip

[divyanshu_srivastava3]

Hi Nainesh,

Register you agent again using below script again

smdsetup managingconf  hostname:"<fqn>" port:"<p4 port>" user:"<value>" pwd:"<value>" servername:"<value>"

Refer:

You should have checked the logs or have searched before posting.

Good Luck

Regards,

Divyanshu

[Former Member]

Dear U R rite

Now i give  scrip which i run

guide me

smdsetup managingconf hostname:"sapslmail.anupamgroup.local" port:"xxxxx" user:"SOLMAN_ADMIN" pwd:"sap12345"

here which port no i give

nainesh

[Former Member]

Hi Nainesh,

Please check the below note for script and port details

1907909 - How to connect Diagnostics Agent to Solution Manager system directly by using smdsetup sc...

1913837 - How to connect Diagnostics Agent to SLD by using smdsetup script

Rg,

Karthik

[Former Member]

Dear Kartik

I all ready Chek Both not and run script and run also but after few minute J2 policy are yello

i dont know why?

Nainesh

[divyanshu_srivastava3]

Hi Nainesh,

Run the above script with dispatcher p4 port 5xx04 directly.  Check if you are able to connect.

Divyanshu