on 03-28-2007 11:36 PM
I have reached the final stage of the configuration of the maintenance
optimizer. I have implemented all of the required notes in the MOPZ
collective note 1024932 (Notes 1008717 - HMTLViewer: Postdata of
length more than 255 gets truncated, (note 950975 is n/a for my system
we have SAPGUI 7.1), Note 975510 - Corrections for calls/interfaces
implmented incorrectly, and 1004691 - SNOTE:
OBJECTS_OBJREF_NOT_ASSIGNED when you implement a note, and the strongly
recommended note 997780 - Maintenance Optimizer: Checks that should
not be executed.
When I try to run the report SM_PREP_MAINTENANCE_OPTIMIZER after
implementing note 990534, I get the following error:
---
For object SOLAR, no sub-object SOLMAN_CONFIG is maintained
Message no. BL011
Diagnosis
An application log entry is to be made for sub-object SOLMAN_CONFIG of
the object SOLAR. This sub-object is, however, not maintained for
object SOLAR.
Objects and subobjects of the application log are created using
transaction SLG0.
System Response
The program had to be cancelled.
Procedure
Inform the system administrator
---
I have verified all of the steps in the document "Step by Step
Configuration of the Maintenance Optimizer". I have also done the
basic IMG settings under Solution Manager in the IMG. I did not
do "Activate integration with the Change Request Management". We are
not using Change Request Management.
Has anyone seen this type of message before? I could do the BC Sets manually but I want to use the report.
Hi
We had the same problem yesterday. We solved it by just entering transaction SLG0, and created the sub-object "SOLMAN_CONFIG" under object "SOLAR".
After that, the report went through without problems.
Regards
Lars
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Thanks Lars. I opened a ticket with SAP and it looks like you can ignore this:
Hello,
You can ignore the message. It is displayed because when the report
runs we try to write the log to the sub-object SOLMAN_CONFIG, which does not exists with Support Package 9, due to it you get the message.
Regarding the 02 options to configure the Maintenance Optimizer it
just occurs becasue the report was not available with Support Package
9 of SAP Solution Manager, however due to the increasing number of
customers that required an easier configuration for the Maintenance
Optimizer we decided to make the report available through the note.
So there is not difference between the 02 configuration options.
The report does exactly the steps described in the alternative
configuration.
I'll give you full points!!
User | Count |
---|---|
87 | |
10 | |
10 | |
9 | |
7 | |
6 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.