on 07-11-2014 8:53 AM
Hi all,
I have the following scenario during goods receipt quality control.
One of he characteristics in my quality plan is "Dimensional control", which is quantitative.
Within this regard, I have to measure dimensions of specific sections on the component.
At each sample, I have to measure all these sections. However, I can only measure as the number of samples.
Any advise, how shall I set the quality plan?
Thanks
Hi Cihan
What do you register in the MIC?
May be you could change the MIC and start to work with qualitative data for this inspection.
Best regards
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Or Else,
See if 'Single Result' in the MIC can meet the requirement.
ntn
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Cihan,
You have to create MIC for each specific section, One MIC for all dimensions of specific sections will not help.
Amol.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
95 | |
11 | |
11 | |
6 | |
6 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.