I got error After adding a start condition to the workflow

[Former Member]

Hello,

I added a start condition to the event 'CHANGEVERSIONSAVED'.

But when i tried to change a PO and reorder it i got the following error:

Cannot get process info from WF archive; function AS_API_READ causes exceptn No Infostruc Found

Can any body help me.

thanks,

Meriem.

[Former Member]

how do i know if there is many workflow triggred for the same start condition?

[Former Member]

in fact, the result of the start condition is false but the workflow is triggred again.

[former_member190689]

Hello Meriem,

     Please check with the WS id which you have activate for PO more than one WS has been activated . Like approval conditions . You can check in SWB_COND

Thanks

Gaurav Gautam

[Former Member]

Hi Gaurav,

Could you please give me steps?

I don't have a big idea about the workflow.

In fact, it's an OSS note 1744002.

thanks,

Meriem.

[former_member190689]

Hello Meriem,

    Can you please tell me about other Events for same BO. Is it activated. A green light shows that it is activated and red shows it's not active. And same is updated in the Event linkage table. So Just check with other whether for same event and BO any other approval level is active. Also would like to know about the expression you are trying to maintain  as I am not sure what exactly you are trying to maintain here . Could you please explain on that part as well.

Thanks

Gaurav Gautam

[Former Member]

Hello Gaurav,

For BOR EC Purchase Order, there are two events activated: CHANGEVERSIONSAVED and SAVED.

The start condition is &_EVT_OBJECT.POTOTALVALUEEUR& >= 0,00 for both events.

In fact, i want to add a start condition so the approval workflow will never trigger again in case of PO's output changement.

I have a doubt that i should add the new condition to other WF not only 14000145.

thanks for your help,

Meriem.

[former_member190689]

Hello Meriem,

     please have a look to the image. This will help you with expression .

Thanks

Gaurav Gautam

[Former Member]

Gaurav,

I don't have a problem with the expression.

I think that there is a conflict between two WF.

How to check the linkage?

Best Regards,

Meriem.

[former_member190689]

Hello Meriem,

      Please remove the last expression ISPOCHANGED and then check it again.

Thanks

Gaurav Gautam

[Former Member]

Hi,

Request you to please below link I think this will solve your problem.

http://scn.sap.com/thread/1723414

Thanks

Ankit Jain

[Former Member]

thanks Ankit, but i have already seen this discussion.

I will check again.

Do you have any other idea.

thanks,

Meriem.