on 07-07-2014 7:35 PM
Hi,
Can anyone tell me the steps to find out which UOM is not having mapped in GTS vs ECC? It doesnot tell which UOM is not passing. It is in production so can't check in GTS.
Thanks in advance.
Hi
The following knowledge Based article details the customising relating to this error:
Are you seeing this error with the transfer of a particular product?
In the material master MM03 (and table marm) you can see unit of measures defined.
You would need to ensure that an ISO code exists in transaction CUNI for each uom defined relating to the material being transfered to GTS.
Hope this helps
Kind Regards
Ann Marie
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Manohar,
Steps remain the same.
In ECC, you have to pick up all the UoM mapped to your product. Check all additional units. Check if there is an ISO code assigned to those Units in table T006. Copy all those ISO codes and go to GTS and check if there is a mapping internal Unit in T006 table in GTS.
Basically you get this message when your product has uom without valid iso code. While you transfer system will send Iso code to gts. In gts this iso code is mapped to internal uom in t006 table.
Regards
Dhilipan
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
13 | |
2 | |
2 | |
1 | |
1 | |
1 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.