cancel
Showing results for 
Search instead for 
Did you mean: 

Output Condition ZFRO

Former Member
0 Kudos

Hi Good Morning I have issue with the put type the output type ZFRO(Order Conf.) is not appearing automatically in SO., however the output ZFRO is defined under output det. ZFI000(Order header). Even though the output is defined in output det. what could be the possible reason for not appearing automatically in SO. Thanks in Advance

Accepted Solutions (0)

Answers (3)

Answers (3)

srinu_s1
Active Contributor
0 Kudos

Please go to va02 output as shown below, check the root cause,

1.May be the output records not maintained in VV11 for the required combiantion

2. check if there is any requirement is not fulfilled ( check any routine is assigned against the order output)

thanks,

Srinu.

Former Member
0 Kudos

Hi Srinu I have checked the first option records are maintained in VV11 on checking the second option Determin. analysis t gives me error condition type ZFRO OUTPUT IGNORED(requirement 802 not fulfilled) Thanks

jpfriends079
Active Contributor
0 Kudos

Refer

1. My post -

2. Check the code written for RV61B802 through TCode SE38. That program will let you know, what is the code logic and why it is not allowing the output to print. To understand the code you can take help of an ABAPer.

Regards,

JP

siva_vasireddy2
Active Contributor
0 Kudos

Hi,

check if you have maintained the Output type condition records along with communication startegy

Former Member
0 Kudos

Hi,

Please make sure the below setting is done for your Output type:

Regards