result field is grayed out in results recording

[Former Member]

Hi all,

I am using dynamic modification rule for one of my inspection lot, when I am doing results recording, I found the "Inspected" and "Result" fields are grayed out and cannot enter anything in these fields. Please see screenshots below.

Regards

Danny

[Former Member · Accepted solution]

Hi Danny,

Please click on + buttton in between the Inspected and Result column. It is show you the field to entry.

Sandip

[aniket_gautam · Accepted solution]

Dear

make sure that in the MIC you have ticked record measured value in the control indicator

Also checked are you doing this in displayed mode if so use qa32 instead

[former_member221124]

Hi Danny

You have mentioned that you are using DMR . If you are using DMR then this lot might have skipped as per your setting of Skip Inspection lot in your DMR.

Please check this and confirm.

Regards

D Mohanty

[Former Member]

It should not be Skip lot, if it is SKIP then the inspection lot should not exist.

[Martin_H]

For a skip lot then you will nevertheless get an inspection lot.

MH